Lifetime Analysis-Modelling
Plastic Pipes Conference Association # 1995 Edinburgh
Choi
A plane strain specimen has been developed which creates a biaxial stress state when loaded in uniaxial tension. A detailed stress analysis of this specimen is presented. The stress state was generated though the use of a groove across the width of the specimen. Both theoretical and experimental results are presented. For polyethylene and similar polymers, the stress state in the groove section was approximately in the ratio 1 :2 which is nearly identical to the stress state in a pressurized pipe. Because of the identity of stress state, this simple specimen becomes a cost-effective and accurate means of predicting pipe long term performance without having to test the pipe itself. In addition to detailing the specimen design, results are presented for polyethylene pipe hydrostatically pressurized at various temperatures and compared to the plane strain tensile specimen tested also at various temperatures. It will be also shown that the best method for plotting creep rupture data is to use the Von-Mises calculated stress and nor simply pipe hoop stress. This specimen and technique wili be advocated as a standard method for evaluating pipe resins.
Related papers
Author(s) : Jörg Wermelinger, Sunwoong Choi
In the development of an international standard on non-destructive test for polyethylene electrofusion socket (EF) joints, the inspection capability of the phased array ultrasonic test (PAUT) in assessing flaws in the joints was needed to establish procedure qualification of the test method. For this, a worldwide...
Author(s) : Sunwoong Choi, Tom Marti
Small scale, steady state (S4) testing per ISO 13477 is a lab-based procedure to determine the critical pressure at which a fracture will propagate following initiation in a given pipe material filled with a given test medium. The S4 test was originally developed for the natural gas industry using air as the test...
Author(s) : Sooho Pyo, Junghyun Nam, Yoonsang Kim and Sunwoong Choi
The Notched Ring Test (NRT) has been recently developed to measure slow crack growth (SCG) in plastics pipes and fittings. The NRT specimen in the form of a notched full ring is directly obtained from the extruded pipe or injection molded fitting and has demonstrated its effectiveness in generating slow crack growth...
Author(s) : Pyo, Seo, Mutter, Broutman, Choi
A novel Notched Ring Test (NRT) method for measuring slow crack growth (SCG) in plastics pipes and fittings is developed and applied to determine its applicability as the standard test method. NRT specimen in the form of a notched full ring, directly obtained from the extruded pipe or injection molded fitting...
Author(s) : Edwards, Broutman, Choi
The Alternate Methods Committee of the Plastics Pipe Institute’s Hydrostatic Stress Board (HSB) has completed development of an alternate method for determining the hydrostatic design basis (HDB) for plastic piping materials. The initial work was reported at Plastic Pipes X, in Sweden in 1998.1 An ASTM test method has...
Author(s) : Choi, Lee, Broutman, Edwards, Palermo, Cho, Choi, Park
In recently designated plane strain grooved tensile (PSGT) methodology of ASTM F2018 standard, a groove in the direction perpendicular to the loading axis allows biaxial stress state to be generated under a uniaxial loading. The biaxial stress state produced very closely approximates the internally pressurized pipes...
Author(s) : Choi
Members of the Association
